Override PCB auto-calculation

In Swingvy, PCB is automatically calculated based on the information provided to the system. To ensure the PCB is correctly computed, you can refer to this article.
 
However, should you want to have a manual PCB deduction for an employee and not following the calculation in Swingvy, it can be done in a few simple steps.
 
Step 1 - Disable auto-calculation for the employee
 Screen_Shot_2020-04-06_at_2.33.00_PM.png
 
Step 2 - During pay run add the Additional PCB for the employee
 
mceclip0.png 
Step 3 - Fill in the fixed amount of PCB for the employee
Step 4 - Complete the pay run

Swingvy tip: 
Swingvy has created a preset Additional PCB item and the amount of the Additional PCB will be populated in the CP39 form.
Have more questions? Submit a request
Was this article helpful?
0 out of 0 found this helpful